Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Share settings delete every reboot
05-03-2017, 08:49 AM
Post: #1
Share settings delete every reboot
Just got the forced Win10Creator from MS and started having issues after I rebooted a few days later...
Drobo 5N, firmware 3.5.1.2 with 5x6TB drives using dual-redundancy, running for over 3 years, using Drobo Dashboard 3.0.0(88901)

I fought for an hour to get the shares to be seen (rebooted Drobo, Reinstalled Dashboard, etc). I was losing the Drobo mount after a few minutes then it couldn't be found.

I lost all the share info so I re-configured all the shares. Now every time I reboot the computer I have to re-configure all the shares again and save them. I don't get any error messages.

Ideas? Thanks!
Find all posts by this user
Quote this message in a reply
05-03-2017, 03:00 PM
Post: #2
RE: Share settings delete every reboot
hi speedyg,
would you be able to try fully exiting dashboard, and then trying to launch it from an admin user (or as an admin with admin rights if possible), and then trying to save and apply any changes you make, but with only 1 change at a time, and with a dashboard shutdown of drobo and a restart of drobo, to see if the same problem still exists or does it improve a bit?

(btw i have XP home SP2, a Drobo v1 with 2x 1TB/2x 1.5TB WD greens, & a bkp Drobo v2 with the same + a DroboShare: unused)
& a DroboS v2 with 3xWD15EADS &2x1TB in DDR mode on win7, & a drobo5D (all usb)
  • btw i did a sustained (write) operation for about 6 hours, and got 13.2MB / sec ...objection? "sustained" :)
    (16.7MB/s on a v2 & 47-96MB/s drobo-s)
Find all posts by this user
Quote this message in a reply
05-03-2017, 06:56 PM
Post: #3
RE: Share settings delete every reboot
Thanks. Yes I will when I have time to do this. It might be a few days.

(05-03-2017 03:00 PM)Paul Wrote:  hi speedyg,
would you be able to try fully exiting dashboard, and then trying to launch it from an admin user (or as an admin with admin rights if possible), and then trying to save and apply any changes you make, but with only 1 change at a time, and with a dashboard shutdown of drobo and a restart of drobo, to see if the same problem still exists or does it improve a bit?
Find all posts by this user
Quote this message in a reply
05-05-2017, 07:13 PM
Post: #4
RE: Share settings delete every reboot
ah thats ok, even if you needed more time, we can still refer to you as "speedy"g Smile

(btw i have XP home SP2, a Drobo v1 with 2x 1TB/2x 1.5TB WD greens, & a bkp Drobo v2 with the same + a DroboShare: unused)
& a DroboS v2 with 3xWD15EADS &2x1TB in DDR mode on win7, & a drobo5D (all usb)
  • btw i did a sustained (write) operation for about 6 hours, and got 13.2MB / sec ...objection? "sustained" :)
    (16.7MB/s on a v2 & 47-96MB/s drobo-s)
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump: