Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Drobo DR/Sync
10-21-2016, 09:13 AM
Post: #1
Drobo DR/Sync
Ok,

So I've got 2 Drobo b810N with 8x4TB Drives

I've done the initial DroboDR Sync and it's been successful for a few days now.

What I'm hoping to do now is take my Target Drobo offsite and have it start doing the syncing remotely, I know I need to open up port 873 (rsync)

But what other ports do I need so that Dashboard etc can access the remote (target) 810?


Also with it setup for DroboDR, I'm assuming the second(remote)unit can not be used for anything else?
Find all posts by this user
Quote this message in a reply
10-21-2016, 01:13 PM
Post: #2
RE: Drobo DR/Sync
(i think it would be best to not use the 2nd, remote unit for anything else, and that ideally it would be similarly-sized as the source)

(btw i have XP home SP2, a Drobo v1 with 2x 1TB/2x 1.5TB WD greens, & a bkp Drobo v2 with the same + a DroboShare: unused)
& a DroboS v2 with 3xWD15EADS &2x1TB in DDR mode on win7, & a drobo5D (all usb)
  • btw i did a sustained (write) operation for about 6 hours, and got 13.2MB / sec ...objection? "sustained" :)
    (16.7MB/s on a v2 & 47-96MB/s drobo-s)
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump: