Drobo 5D doesn't mount drives and enters in on/off loop
|
03-24-2017, 02:32 AM
Post: #1
|
|||
|
|||
![]()
Hi everyone!
This is my first post here. I've read some of the other similar posts, but I'm not sure if this is the same issue. This is my first problem with Drobo 5D. It's out of warranty so support can't help me... Yesterday all was fine, but today as I turned it on, all vertical lights turn on (yellow or orange), then all the blue in the bottom. Then after a while, without mounting any discs, it shuts all lights down and starts over. I've taken out all discs and it has exactly the same behavior. The light on the power box is fixed green, no problems that I can see in the cord. Is this a power supply issue? Should I buy one? Or is this more serious? Thanks so much! - Patricia Carvalho |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Drobo 5D doesn't mount drives and enters in on/off loop - misspato - 03-24-2017 02:32 AM
RE: Drobo 5D doesn't mount drives and enters in on/off loop - Paul - 03-24-2017, 08:23 PM
|